TuneHow to tune a flute
- Press Start Tuning and allow microphone access when your browser asks.
- Play one note. Play one long, steady note, close to the microphone, and let it ring.
- Read the display. The big letter is the nearest note. The bar shows how far off you are: left is flat (tune up), right is sharp (tune down).
- Turn until it goes green. Inside your tolerance (±3 cents by default) the display turns green and the string gets a check mark.
Tips
- Pull the headjoint out to go flatter, push it in to go sharper.
- Tune on A4, then check low D and high A for octave balance.
- Rolling the flute in lowers pitch; keep your normal angle while tuning.
FAQ
Does this flute tuner show written or concert pitch?
The flute plays in concert pitch, so written and sounding notes are the same.
Why am I sharp at the start and flat later?
Instruments warm up as you play. Tune after a few minutes of playing, and check again during long rehearsals.
Can I tune to A = 442 Hz?
Yes. Open Settings and set Reference A4 to 442, or any value from 400 to 480 Hz.